Device

UPS Smart Monitor

An interposer fitted between the mains and your existing UPS. It measures what happens on both sides, can simulate a mains failure for testing purposes and reports over GSM. It turns a simple backup unit into one you actually know about.

Wiring principle

The module sits in series. On the input it measures what the UPS draws from the mains; on the output, what the UPS delivers to the backed-up circuit. Plus battery set voltage and temperatures.

Mains

input

UPS Smart Monitor

measuring + switching

UPS

existing unit

Backed-up circuit

e.g. emergency lighting

Additional sensors

  • Ambient temperature in the switchboard
  • Temperature inside the UPS
  • Battery box temperature (optional)
  • Battery set voltage

Construction

The device is designed to fit an ordinary switchboard without rebuilding it, and so that a fault in the module can never disconnect the backed-up circuit.

Mounting DIN rail, up to 6 modules wide
Ingress protection min. IP20 inside the switchboard
Current measurement without breaking the conductor where possible
Indication status LEDs for the technician
Service interface local USB or BLE, works without internet
Firmware updates remote, dual bank with rollback
Identification unique device ID paired with the SIM
Own power supply battery or supercapacitor, survives a mains failure

Safety comes first here

In active mode the module is fitted in series with the emergency lighting circuit — an element on which the safety of people depends. Several things follow from that, none of them optional.

A fault must not put the lights out

The switching element is closed at rest. On loss of power or a logic fault the circuit stays energised — the module removes itself from the path rather than breaking it.

Watchdog on loss of communication

If the link to the server drops during a test, the module restores the input by itself. It never remains in the disconnected state.

Conformity assessment and CE

The device must undergo conformity assessment and be designed by a qualified electrical engineer. Compliance with requirements for emergency lighting circuits is assessed together with an inspection engineer.

The device is under development. Before it goes into service at customer sites it will undergo conformity assessment and verification by an inspection engineer.

Communication

Warehouses tend to have weak signal and unstable data. SMS is therefore the primary channel — it gets through where a data connection drops.

SMS first

A regular heartbeat carrying measured values, an immediate message on alarm and on test results, and commands towards the module.

Data second

Where LTE, NB-IoT or LAN is available, full telemetry runs at higher resolution over it. SMS remains as fallback.

Adaptive interval

Reporting frequency is configured per device and changed remotely — more often where it matters.

How you get one

UPS Smart Monitor is not sold separately. We supply it as part of the monitoring service — including installation, commissioning and calibration against your particular circuit. Without calibration the measured values would have no reference point to compare against.

It starts with a UPS audit of the estate

We survey the whole site — including backed-up systems nobody currently keeps records of. The output is an inventory of the equipment, its condition and a proposal for what is worth monitoring. Only then does a quotation follow.